Hymer - Climbing Ladders Sida 8
Kommersiell Kunderbjudande **Toppförsäljare från HYMER
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
DIN 18799-1 / DIN 18799-3 (ACCESORIES) LADDER FOR MAINTENANCE OF A BUILDING · The top rung must be at the exit level. · From an access height of 10,000 mm, the ladder must be · · · installed with offset. The maximum length of a ladder section must not exceed 10,000 mm. The offsets are to be positioned at equal intervals, but can also be planned at different heights using the online configurator. Distance of the rung-leading-edge of the ladder must be at least 200 mm, but may be reduced to 150 mm in the event of obstacles (e.g. pipes). When using access protection (individual fall protection), the use of the vertical ladder system must only be carried out by experienced persons. Exception: If offsets are not possible for structural reasons, the ladder may also have a single-section longer than 10,000 mm. In this case, the offset must be replaced with a resting platform. Exit: The gap between the vertical ladder and the exit level must not exceed 75 mm. For a standard wall distance between ladder and building of 210 mm, this 75 mm gap is provided by using an exit step. Unsecured exit areas must be equipped with a lateral guardrail or a railing on both sides towards the roof area. · · Fastening: · The standard wall mounting has a gap of 210 mm from the stile axis to the building. The · distance between the individual fastening points must not exceed 2,000 mm. They should preferably be attached directly below the rungs. Safety cage: Distance from the lowest safety cage clamp to the floor: 2,200 mm to 3,000 mm. Safety cage required from a height of 3,000 mm. · · 8 Continuous fall protection on request
40 Sidor | Gäller till 12/2025 | Previous page | Nästa sida
Välj ditt språk
Juridiska frågor
Tillverkaren ansvarar exklusivt för innehållet, priset och artikeldetaljerna för produkterna och erbjudanden som presenteras i katalogerna. Med förbehåll för tekniska och optiska ändringar av tillverkaren och undantag för fel.
Formulär för specialprodukter
ToolTeam® upphandlingstjänst
Letar du efter produkter som visas i katalogen men inte kan köpas direkt online?Vår upphandlingstjänst kommer med glädje att ge dig ett icke-bindande och individuellt erbjudande.
