Hymer - Climbing Ladders Sida 7
Kommersiell Kunderbjudande **Toppförsäljare från HYMER
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
NECESSARY INFORMATION Facade structure/cross-sections Z Example 1: direct mounting on the facade Wall thickness (Z) ·Type of facade (concrete, solid brick, perforated brick, wood, trapezoidal sheet metal, sandwich panels, etc.) Example 2: Installation on curtain wall Wall thickness of the load-bearing wall (Z) ·Type of load-bearing wall (concrete, solid brick, perforated brick, wood, X Y Z trapezoidal sheet metal, sandwich panels, etc.) Thickness of insulation layer (Y) ·Type of insulation layer (mineral fibre, insulation panels, layer of air) Curtain wall thickness (X) ·Type of curtain wall (solid brick, perforated brick, wood, trapezoidal sheet metal, sandwich panels, etc.) Facade features This information is important for using the appropriate wall brackets. This information is important for the correct mounting position. B Example sketch of a single-section vertical ladder A Vertical climbing height C (floor to top of access height) Rooftop level B Fascia width (omitted if roof level is at the same height) J Rooftop level ? C Height difference For access heights above 10 m, the vertical ladder should be installed using several staggered sections. B (upper edge of access height to upper edge of roof level) I Vertical access height approx. 8.20 m D Vertical height to first offset H F A In the event of further offsets, always use the respective intermediate dimensions specify (E | F | G | H | I | J). Important: Indication whether offset is inwards or outwards. ? ? Dimensions are also required for components such as gutters, etc. E (2,200 to 3,000 mm) ? I Other dimensions G A Desired dimension of lower edge of safety cage (Please note: exterior lighting, cable ducts, etc.) For escape ladders, please specify the position of the exit platforms. ? D B Minimum width 800 mm A ? 7
40 Sidor | Gäller till 12/2025 | Previous page | Nästa sida
Välj ditt språk
Juridiska frågor
Tillverkaren ansvarar exklusivt för innehållet, priset och artikeldetaljerna för produkterna och erbjudanden som presenteras i katalogerna. Med förbehåll för tekniska och optiska ändringar av tillverkaren och undantag för fel.
Formulär för specialprodukter
ToolTeam® upphandlingstjänst
Letar du efter produkter som visas i katalogen men inte kan köpas direkt online?Vår upphandlingstjänst kommer med glädje att ge dig ett icke-bindande och individuellt erbjudande.
