Ganter Norm Standard Parts - Catalogue Sida 1644
Kommersiell Kunderbjudande **Toppförsäljare från Ganter Norm
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
Universal Joints and Universal Joint Shafts 3.4 3.3 In order to obtain a smooth rotation, two single or one double universal joint is required. In such cases where minor irregularities in the movement are acceptable or where minor inclination angles are the norm, a single universal joint will do. 3.2 The single universal joints transfer the initial steady rotation as an irregular rotation because one revolution of the drive shaft using the single universal joint will cause the driven shaft to accelerate and decelerate twice. The extent of the irregularity depends on the operating angle ß. 3.1 Mounting Information 3.8 If the universal joint shafts are connected incorrectly, the irregular rotation of each joint is not compensated, but strengthened. This can destroy joint bearings and wedge profiles. For this reason, the markings of the universal joint shaft halves have to be opposite to each other when connecting them. 3.7 3.6 3.5 For a steady transfer of rotation, the inclination angles ß must be equal on both ends of the connecting shaft. For continuous operation of universal joints with friction bearings, adequate lubrication is essential. If drip lubrication is not possible, they should be lubricated at least once a day. It is also possible to fit the universal joint with a gaiter GN 808.1 which can be filled with oil or grease. 3.6 Moving, Transferring, Connecting with Shafts and Joints | Page 1643 3.9 Furthermore, the bearings must be as close as possible to the universal joints.
2210 Sidor | Gäller till 12/2026 | Previous page | Nästa sida
Välj ditt språk
Juridiska frågor
Tillverkaren ansvarar exklusivt för innehållet, priset och artikeldetaljerna för produkterna och erbjudanden som presenteras i katalogerna. Med förbehåll för tekniska och optiska ändringar av tillverkaren och undantag för fel.
Formulär för specialprodukter
ToolTeam® upphandlingstjänst
Letar du efter produkter som visas i katalogen men inte kan köpas direkt online?Vår upphandlingstjänst kommer med glädje att ge dig ett icke-bindande och individuellt erbjudande.
