Rothoblaas - X-RAD Page 25
Offre client commercial**Meilleures ventes de RothoBlaas Deutschland
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
X-ONE X-PLATE X-SEAL POSITIONING Independently of the thickness of the panel and its location on the site, the cut for the fastening of X-ONE is made at the tops of the walls, at 45°, and it is 360,6 mm long. STANDARD MIDFLOOR AND TOP NODES CUT (1) STANDARD BASIC NODES CUT (1) s min. 300 (2) 255 255 s/2 100 255 0,3 18 45° 0,3 18 0,6 36 255 45° X-ONE is fixed on the inclined surface in a central position, both with respect to the length of the cut and in the direction of the panel thickness (s). This rules holds for all the thicknesses of the panel. The creation of a specific housing for the floor panels avoids the interposition of the slabs between the wall panels and the resulting problems related to compression at right angles to the fibres. It thus allows direct transmission of vertical loads between the wall panels in concentrated zones at the ends of them. NOTES: (1) For non-standard cases see pages 62-63. (2) We recommend not making cuts in and processing the CLT panel within a radius of 300 mm from the tops of X-ONE, in order to avoid damaging the fastening screws and cutting tools. X-ONE 23
84 Pages | Valable jusqu’au 04/2024 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.
