Eurotec Catalogue Lifting and Transport Solutions Page 29
Commercial customer offer**Top sellers from Eurotec
Timber engineering TILTING OF CLT PANELS To tilt CLT wall panels from a horizontal position to a vertical position, the base of the wall shall act as support so that half of the gravity load is transferred through direct contact, and the lifting devices carry the other half. Therefore, the permissible capacities can be used per anchor point as shown in the table above for the CLT wall with respect to B=0° Due to out-of-plane shear loading at the initial stage, the edge distance of a4,t shall be satisfied for screws. However, screws should not be inserted in the glue line. Hence, CLT thickness should be checked as follows. Powerblock-M: · Minimum CLT wall thickness ≥ 120 mm (2 screws in the middle layer) and 160mm (4 screws at the outer layers) Powerblock-L: · Minimum CLT wall thickness ≥ 120 mm (4 screws in the middle layer) and 170mm (8 screws at the outer layers) If you are not familiar with how this product is used, and particularly with the product’s intended use, please contact our Application Technology department ([email protected]). 29
58 Pages | Valid until 12/2026 | Previous page | Next page
Choose your language
Legal issues
The manufacturer is exclusively responsible for the content, price and article details of the products and offers presented in the catalogues. Subject to technical and optical changes by the manufacturer and errors excepted.
Request form for special products
The ToolTeam® Procurement Service
Are you looking for products that are shown in the catalogue but cannot be purchased directly online?Our procurement service will be pleased to make you a non-binding and individual offer.