Chipboard screws with countersunk head, PZ cross recess

(418)

This category covers chipboard screws with countersunk head and PZ cross recess from the Fischer assortment. They are suitable for joining chipboard and other wood-based panels, with the countersunk head allowing for a flush finish.



What are chipboard screws with countersunk head suitable for?

Chipboard screws with countersunk head are primarily used for joining chipboard, OSB boards and similar wood-based materials. The flattened head (countersunk head) allows the screw to be sunk flush with the surface, which is important for subsequent cladding or painting. The PZ cross recess drive provides good force transmission and reduces the risk of the screwdriver slipping out of the screw head.

What are the differences between these screws?

Within this category, the screws differ mainly in their length and thread area. There are variants with full thread and partial thread. The choice between these variants depends on the thickness of the materials to be joined and the desired holding power. In addition, the screws are available in various diameters, which must match the size of the hole and the material thickness.

How do I choose the right screw?

When selecting, you should consider the thickness of the panels to be joined as well as the type of substrate. For joining two chipboards, a screw with partial thread is generally chosen, which has a thread in the upper panel and serves as a smooth shank in the lower panel to allow the panels to be screwed together. The length of the screw should be dimensioned so that it securely penetrates both materials without damaging or breaking through the lower material.

Oblíbené značky