Woelm Catalogue KWS Door Pulls, Door Handles and Accessories Sida 70
Kommersiell Kunderbjudande **Toppförsäljare från HELM KWS by Woelm
exkl. Frakt
KWS Door pull fixing KWS 8A73.. S 23 - M 6 for Ø 20 door pull KWS 8B73.. S 23 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). KWS 8A79.. S 29 - M 6 for Ø 20 door pull KWS 8B79.. S 29 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Standard design steel blue passivated .06 stainless steel .80 natural finish Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Standard design for door pulls of Aluminium inner parts steel blue passivated and rosettes: .22, .23, .24, .27, .28, .29, .70 brass inner parts stainless steel and rosettes: .61, .65 stainless steel Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). inner parts stainless steel and rosettes: .82, .83 Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers, rosettes and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Order example Set ... Set Part no. Finish no. Fixing type KWS 8A73 .80 S 23.2 70 TEK_0308/06.2017
104 Sidor | Gäller till 12/2020 | Previous page | Nästa sida
Välj ditt språk
Juridiska frågor
Tillverkaren ansvarar exklusivt för innehållet, priset och artikeldetaljerna för produkterna och erbjudanden som presenteras i katalogerna. Med förbehåll för tekniska och optiska ändringar av tillverkaren och undantag för fel.
Formulär för specialprodukter
ToolTeam® upphandlingstjänst
Letar du efter produkter som visas i katalogen men inte kan köpas direkt online?Vår upphandlingstjänst kommer med glädje att ge dig ett icke-bindande och individuellt erbjudande.