Klingspor main catalogue Abrasive, cutting-off & grinding discs Sida 434
Kommersiell Kunderbjudande **Toppförsäljare från Klingspor
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
exkl. Frakt
Klingspor jigsaw and reciprocating saw blades Technical Glossary Teeth per inch Teeth per inch 25 TPI clean cut slow 1 TPI Al rough cut fast Tooth pitch Blade length 2-3 teeth should always work inside the material. A rule of thumb for the toothed length of the saw blade: Width of the material plus 50 mm 130 mm + 25 mm 434 80 mm + 25 mm The tooth pitch is defined as the distance between two tips of a saw blade. It is specified in either inches or millimetres. Note: The softer the material is, the wider the tooth pitch of the saw blade should be. Because: Softer materials produce more chips during sawing than harder ones. The spacing between two tips of the sawing blade provides room for these chips. If the spacing of the saw blade tips is too small, chip removal will deteriorate and cause the saw to work more slowly and may even cause it to jam in extreme cases.
440 Sidor | Gäller till 12/2027 | Previous page | Nästa sida
Välj ditt språk
Juridiska frågor
Tillverkaren ansvarar exklusivt för innehållet, priset och artikeldetaljerna för produkterna och erbjudanden som presenteras i katalogerna. Med förbehåll för tekniska och optiska ändringar av tillverkaren och undantag för fel.
Formulär för specialprodukter
ToolTeam® upphandlingstjänst
Letar du efter produkter som visas i katalogen men inte kan köpas direkt online?Vår upphandlingstjänst kommer med glädje att ge dig ett icke-bindande och individuellt erbjudande.
