Bernardo complete catalog of protective devices Sida 9
Kommersiell Kunderbjudande **Produkter från katalogsidan
Safety supplies PAT/PLT PAT 01 - Roll-up safety guard for lathe advancing bars Made of two units of self-rolling-up rolls, with tear and oil-resistant thread. Designed for protecting the operator against the machine advancing bars. The item is created for the frontal “segregation” of the lathe mother screw and the advancing bars. It is protecting the operator against direct contact with moving parts and avoiding the possibility of “snagging” of working garments. Made up of two units to be fixed to the two extremities of the longitudinal carriage, equipped with a particular self-sliding roll, operated from the inside by multiple springs. The protective ribbon is made of spread textile material and is resistant to coolants and abrasions. Each unit is purposely designed for its side of the carriage and is equipped with appropriate anchorage stirrups. During movement of the longitudinal carriage, the two units self- roll and unroll, constantly “segregating” the lathe mother screw and the advancing bars. Note: the extremity, equipped with the sliding roll, must be fixed onto the base side PAT 01/120 PAT 01/150 PAT 01/200 PAT 01/300 A 1200 1500 2000 3000 B 150 200 200 250 1 Base-side angular anchorage stirrups made of pressed steel 2 Carriage-side angular anchorage stiruups made of aluminium 3 Self retracting by internal torsion spring. The roll is made of steel and aluminium 4 Protective ribbon made of spread technical tread C 180 230 230 280 D 90 140 140 190 Art. no. 57-1105 57-1106 57-1107 57-1108 Price excl. VAT PLT 02 - Lathe safety lever Double-movement universal device, for the insertion of chuck rotation. Provided in a single piece, to be installed as a replacement for one of the two original levers. It allows the activation of chuck rotation, performing a forced “double movement” manoeuvre. Suitable for installation on machines with one or two levers. Provided in a single piece, to replace only one of the two original machine levers, normally identified as the most frequently used one, while the original remaining lever remains operational only for disconnection. Equipped with a universal levelling plate where a hole has to be made that is corresponding to the central “neutral” position. In this way, the safety bolt on the joint are entering into the hole, which in turn, in case of involuntary activation, is setting the lever locking. Activation of the chuck rotation occurs by performing in sequence: movement 1° and subsequently movement 2° - Disconnection occurs by directly performing movement 2° until the introduction of the safety bolt into the locking hole. 1 Adjustable angular anchorage stirrup made of pressed steel 2 Levelling plate, to insert the locking pivot made of pressed steel 3 Shaft to be inserted in the original joint of the chuck bar, made of steel 4 Joint equipped with safety pivot and recall spring made of steel 5 Adjustable safety bolt 6 Manoeuvre lever equipped with round knob PLT 02/360 Weight Art. no. 1,9 kg 57-1111 Price excl. VAT 7
32 Sidor | Gäller till 12/2022 | Previous page | Nästa sida
Välj ditt språk
Juridiska frågor
Tillverkaren ansvarar exklusivt för innehållet, priset och artikeldetaljerna för produkterna och erbjudanden som presenteras i katalogerna. Med förbehåll för tekniska och optiska ändringar av tillverkaren och undantag för fel.
Formulär för specialprodukter
ToolTeam® upphandlingstjänst
Letar du efter produkter som visas i katalogen men inte kan köpas direkt online?Vår upphandlingstjänst kommer med glädje att ge dig ett icke-bindande och individuellt erbjudande.