Kemmler Main Catalog Precision Tools Página 862
Oferta para clientes comerciais**Vendedores mais populares de Kemmler Präzisionswerkzeuge
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
High precision collet chucks KPS-system The high precision collet chuck (KPS) is the alternative to hydraulic expansion chucks and shrink chucks. High flexibility due to interchangeable collets (precision collets System KPS available from Ø 0.5 up to 16 mm). High clamping forces and concentricity lead to top surfaces and longer tool life. Plain clamping nut without grooves for high speed machining. Slim version. Tool shanks: Cylindrical DIN 1835-1 form A/DIN 6535 form HA, tolerance h8. Dedicated clamping size on the nominal diameter. Collets available in steps of 0.5 mm. Run-out: Maximum runout when measured at a gauge projection of 4×d in relation to the external taper is 5 μm. Balancing: Fine balancing is standard (G 2.5 30,000 min–1). Note: KPS-system chucks are delivered as standard without stop end screws. The use of stop end screws is not recommended at high spindle speeds, e.g. over 10,000 rpm. Collet chuck size Capacity d mm D L1 M D16 1 – 10 27 19 M20 × 1 D24 2 – 16 36 22 M28 × 1 S Max. tightening torque D type clamping system max. Rpm* 24 40 Nm 60,000 32 70 Nm 40,000 * The maximum rpm for holders equipped with this clamping system is often restricted by the holder‘s back-end taper type and size. 13 13.65 K43
918 Páginas | Válido até 12/2025 | Página anterior | Próxima página
Escolha a sua língua
Questões legais
O fabricante é exclusivamente responsável pelo conteúdo, pelo preço e pelos detalhes dos produtos e das ofertas apresentados nos catálogos. Sujeito a alterações técnicas e ópticas por parte do fabricante e com excepção de erros.
Formulário de pedido de produtos especiais
O serviço de aquisições de ToolTeam®
Está à procura de produtos que são mostrados no catálogo mas que não podem ser comprados diretamente online?O nosso serviço de aprovisionamento terá todo o prazer em fazer-lhe uma oferta individual e não vinculativa.