Ganter Norm Standard Parts - Catalogue Página 1574
Oferta para clientes comerciais**Vendedores mais populares de Ganter Norm
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
excl. o transporte
Electrical specifications 3.1 GN 650.5 Oil Level Indicators continued Oil level monitoring Temperature monitoring Max. switching voltage / Max. switching current: 250 V AC / 10 A 48 V DC / 5 A 3.2 Max. switching voltage / 150 V AC, 100 V DC / 1 A (NO) Max. switched current: 150 V AC, 150 V DC / 2 A (NC) Max. switching capacity: 10 W (NO) / 20 W (NC) Connector plug: Protection class: Cable gland: Cable cross-section: DIN EN 175301-803 type C IP 65 PG 7, for cable Ø from 6 to 7 mm 2 x 1,5 mm² 3.3 Oil level and temperature monitoring 3.4 Caution: Magnet fields impair the proper function! Assembly sequence for cable connection 2. Push the contact holder out off the connector casing. 3.5 1. Loosen the mounting screw and pull off the connector plug. 4. Push the contact holder back into the connector casing and tighten the cable gland for strain relief grip / seal. 3.6 3. Loosen the cable gland, feed the cable through the connector casing and connect to the contact holder. 3.7 5. Push the connecting plug over the connecting contacts of the oil level indicator and secure with mounting screw. For the best possible sealing effect of the O-rings, do not overtighten the screws (max. 12 Nm). Recommended roughness of the sealing flange surface Ra = 3 μm. 3.5 Controlling, Venting, Sealing of Liquids and Gases | Page 1573 3.9 Two tapped holes M12 are required for mounting the oil level indicator GN 650.5. If nuts are used for mounting, two Ø 12.5 bore holes are required. 3.8 Assembly instructions
2210 Páginas | Válido até 12/2026 | Página anterior | Próxima página
Escolha a sua língua
Questões legais
O fabricante é exclusivamente responsável pelo conteúdo, pelo preço e pelos detalhes dos produtos e das ofertas apresentados nos catálogos. Sujeito a alterações técnicas e ópticas por parte do fabricante e com excepção de erros.
Formulário de pedido de produtos especiais
O serviço de aquisições de ToolTeam®
Está à procura de produtos que são mostrados no catálogo mas que não podem ser comprados diretamente online?O nosso serviço de aprovisionamento terá todo o prazer em fazer-lhe uma oferta individual e não vinculativa.
