Ganter Norm Standard Parts - Catalogue Pagina 1574
Commercieel klantenaanbod**Beste verkopers van Ganter Norm
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
excl. verzending
Electrical specifications 3.1 GN 650.5 Oil Level Indicators continued Oil level monitoring Temperature monitoring Max. switching voltage / Max. switching current: 250 V AC / 10 A 48 V DC / 5 A 3.2 Max. switching voltage / 150 V AC, 100 V DC / 1 A (NO) Max. switched current: 150 V AC, 150 V DC / 2 A (NC) Max. switching capacity: 10 W (NO) / 20 W (NC) Connector plug: Protection class: Cable gland: Cable cross-section: DIN EN 175301-803 type C IP 65 PG 7, for cable Ø from 6 to 7 mm 2 x 1,5 mm² 3.3 Oil level and temperature monitoring 3.4 Caution: Magnet fields impair the proper function! Assembly sequence for cable connection 2. Push the contact holder out off the connector casing. 3.5 1. Loosen the mounting screw and pull off the connector plug. 4. Push the contact holder back into the connector casing and tighten the cable gland for strain relief grip / seal. 3.6 3. Loosen the cable gland, feed the cable through the connector casing and connect to the contact holder. 3.7 5. Push the connecting plug over the connecting contacts of the oil level indicator and secure with mounting screw. For the best possible sealing effect of the O-rings, do not overtighten the screws (max. 12 Nm). Recommended roughness of the sealing flange surface Ra = 3 μm. 3.5 Controlling, Venting, Sealing of Liquids and Gases | Page 1573 3.9 Two tapped holes M12 are required for mounting the oil level indicator GN 650.5. If nuts are used for mounting, two Ø 12.5 bore holes are required. 3.8 Assembly instructions
2210 Pagina’s | Geldig tot 12/2026 | Vorige pagina | Volgende pagina
Kies uw taal
Juridische kwesties
De fabrikant is exclusief verantwoordelijk voor de inhoud, prijs en artikeldetails van de producten en aanbiedingen in de catalogi. Technische en optische wijzigingen door de fabrikant en fouten voorbehouden.
Aanvraagformulier voor speciale producten
De ToolTeam® Inkoopservice
Bent u op zoek naar producten die wel in de catalogus staan maar niet direct online te koop zijn?Onze aankoopdienst zal u graag een niet-bindend en individueel aanbod doen.
