Catalogue principal Kemmler Outils de précision Page 853
Offre client commercial**Meilleures ventes de Kemmler Präzisionswerkzeuge
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
Operating and user instructions for hydraulic expansion chucks To ensure a flawless function of the hydraulic expansion chucks, please observe the following instructions: Usage of straight shank tools according to DIN 1835 and DIN 6535 form (HA) and B (HB) up to Ø 20 mm shaft diameter with tolerance h6, precision grinded Ramin = 0.3. Shafts according to DIN 6535 form HE (Whistle Notch) can only be clamped by using reduction sleeves. All hydraulic expansion chucks are standard balanced to G 6.3 15,000 rev/min. Clamping and unclamping the tool 1. Clean the holding fixture bore and the tool shaft of grease and dirt. Insert tools up to the end stop. Observe the minimum clamping depth and the length adjustment range. 2. Clamp the shaft by turning the clamping screw up to the end stop. The tool is clamped. To avoid breaking of the hydraulic sleeve, do not carry out clamping action without a tool. 3. To unclamp the tool, turn the screw approx. 5 to 6 revs. counter clockwise and remove the tool. Note: Never clamp without a clamped tooling! 1 2 DIN 1835 A/DIN 6535 HA DIN 1835 B/DIN 6535 HB up to Ø 20 mm Cleaning Attention should be paid to the cleanliness of the holding fixture bore and the tool shaft. Temperature Optimal temperature range between 10 – 50°. Do not use with temperatures above 80°. Storage Store the hydraulic expansion chuck untensioned, cleaned and lightly oiled. Clamping shafts Clamp only tool shafts conforming to the requirements of DIN 1835 form A and form B (up to 20 mm). 13 K43 13.56
918 Pages | Valable jusqu’au 12/2025 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.