Woelm Catalogue KWS Door Pulls, Door Handles and Accessories Page 70
Offre client commercial**Meilleures ventes de HELM KWS by Woelm
hors Expédition
KWS Door pull fixing KWS 8A73.. S 23 - M 6 for Ø 20 door pull KWS 8B73.. S 23 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). KWS 8A79.. S 29 - M 6 for Ø 20 door pull KWS 8B79.. S 29 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Standard design steel blue passivated .06 stainless steel .80 natural finish Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Standard design for door pulls of Aluminium inner parts steel blue passivated and rosettes: .22, .23, .24, .27, .28, .29, .70 brass inner parts stainless steel and rosettes: .61, .65 stainless steel Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). inner parts stainless steel and rosettes: .82, .83 Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers, rosettes and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Order example Set ... Set Part no. Finish no. Fixing type KWS 8A73 .80 S 23.2 70 TEK_0308/06.2017
104 Pages | Valable jusqu’au 12/2020 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.