Rothoblaas - Timber Construction Page 161
Offre client commercial**Meilleures ventes de RothoBlaas Deutschland
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
GENERAL INFO 975 MULE must be installed on the bearing structure, namely on timber joists that are continuous and intact. The load-bearing capacity of the joist in the presence of MULE is to be verified separately. Damaged MULE elements must not be used. The assembly and disassembly operations of MULE must be carried out by staff that is trained in safety matters and suitably protected against the risk of falling from a height. 1250 ASSEMBLY The beams must have a minimum width of 60 mm. Basically, the MULE must be hooked onto the battens (max. thickness = 43 mm), above the beams. This hooking will facilitate assembly. Each MULE must be anchored to the beams with: A. 1 HBS timber screw Ø10 mm (minimum screwing depth in the beams = 60 mm) B. 2 HBS timber screws Ø10 mm (minimum screwing depth in the beams = 96 mm) It is recommended to interpose the distance between the MULE and the structure (B). If appropriate, pre-drill with holes d = 6 mm. Lock the support C in the support U D with the coupling E so that the support surface F is as horizontal as possible. With coupling E it is possible to guarantee a maximum load per pair of MULE = 7,8 kN. If the MULEs are used as support for a total load of more than 10 kN/pair, it is necessary to replace the coupling E with one screw M12 x 70 (steel class 8.8) not included in the supply. A F B C D E LOAD CENTRE OF GRAVITY In case of fastening with a minimum inclination, make sure that the centre of gravity of the load is in the position shown in the figure. < 50 cm INDISPENSABLE Thanks to its versatility, it is an indispensable tool for any work on roofs. LOAD CAPACITY Each pair of MULE is capable of carrying a load of 780 kg. TRANSPORT AND LIFTING | MULE | 161
241 Pages | Valable jusqu’au 04/2024 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.
