Rothoblaas - Plates and Connectors Page 144
Offre client commercial**Meilleures ventes de RothoBlaas Deutschland
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
DIFFUSE AND CONCENTRATED JOINTS FORCE TRANSFER MODE Joints with cylindrical shank connectors transmit the load through high and very localised shear forces: these are transmitted in the structural elements in an uneven manner, stressing a limited volume of timber (demonstrated by the blue areas in the adjacent diagram) . Joint with cylindrical shank connectors . XEPOX epoxy adhesive and SHARP METAL technology allow to spread the load over a very wide area compared to that involved by a cylindrical shank connector . This results in a more homogeneous and less severe stress on the wood component . Joint glued with XEPOX . Joint with SHARP METAL . SCALE FACTORS Cylindrical shank connections typically have diameters between 4 and 20 mm and are loaded with forces proportional to this dimension . Since the force is concentrated, when using these connectors it is necessary to respect the minimum distances and spacing, in order to avoid fragile failures along the stressed wood fibre . In addition, when using connectors with a large diameter, there is a considerable weakening of the net cross-section of the timber elements at the drill holes . The mechanical engagement of the SHARP METAL hooked surface and the pull-through into the timber structure of the XEPOX adhesive allow a load distribution over the whole connected timber area, avoiding splitting and weakening of the cross-section . 144 | DIFFUSE AND CONCENTRATED JOINTS | EPOXY ADHESIVES AND HOOKED PLATES
576 Pages | Valable jusqu’au 04/2024 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.
