KS Tools special tools for utility tools and transporters Page 286
Offre client commercial**Meilleures ventes de KS Tools
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
SAC clutch removal 1. Select the appropriate centring pin depending on the pilot bearing diameter and screw onto the clamping mandrel with the receiving thread M8. 2. Equip the clamping mandrel with the appropriate clamping sleeve, depending on the hub diameter of the clutch disc. 3. Insert the fully equipped clamping mandrel (relaxed clamping sleeve) into the pilot bearing. 4. Guide the new clutch disc over the centring device and insert into the flywheel receptacle. Attention: It is important for an optimal guiding that the centring pin is close-fitting in the pilot bearing. 5. Now the clamping sleeve is braced in the hub of the clutch disc by securing the clamping mandrel with one hand and using the other hand to actuate the drive on the mandrel end so that the clamping sleeve spreads in the hub (finger tightening is sufficient). 6. Place the new clutch pressure plate on the flywheel (note centring pins). Select the matching threaded bolts and screw 3 threaded bolts into the flywheel hand-tight offset by 120°. Offset by 90° for 4-pitch! (e.g. Mercedes W169 A-class from MJ 2004). Attention: Always screw the short thread end into the flywheel. 7. Attention: Pressure plate does not abut! 8. Correct: Pressure plate abuts! 9. Insert the cover fastening screws into the open threaded receptacles of the flywheel and tighten. 286
528 Pages | Valable jusqu’au 07/2024 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.
