Ganter Norm Standard Parts - Catalogue Page 793
Offre client commercial**Meilleures ventes de Ganter Norm
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
Toggle Clamps Knee Lever Principle Pneumatic toggle clamps combine the advantages of clamping with the knee lever principle (clamp remains closed even after a loss of pressure) with the capabilities of pneumatic operation. Movement phase 1 The clamping arm opens wide enough that the full surface of the workpiece is exposed, allowing it to be removed or placed into the mechanism without obstruction. Movement phase 2 Even a slight turning of the clamping lever brings the clamping arm with the spindle assembly onto the workpiece. The arrangement of the three knee joints as shown makes clear that the clamping arm exerts many times the operating force on the lever. However, the toggle clamp is not yet locked in this position; in other words, opposing forces on the clamping arm would open it again. Movement phase 3 When all three joints of the knee lever are in alignment, the maximum clamping force FS is achieved (lever dead point). Movement phase 4 In this position, i.e. the clamping position, the lever dead point is exceeded by a specific amount and the clamping lever is fixed in place by an end stop. This ensures secure locking (self-blocking) of the toggle clamp. The force that can be absorbed by the clamping element in this closed state without lasting deformation is referred to as the retaining force retaining force FH. Page 792 | 2.4 Tensioning with Clamping Mechanisms
2210 Pages | Valable jusqu’au 12/2026 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.
