Ganter Norm Standard Parts - Catalogue Page 1574
Offre client commercial**Meilleures ventes de Ganter Norm
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
hors Expédition
Electrical specifications 3.1 GN 650.5 Oil Level Indicators continued Oil level monitoring Temperature monitoring Max. switching voltage / Max. switching current: 250 V AC / 10 A 48 V DC / 5 A 3.2 Max. switching voltage / 150 V AC, 100 V DC / 1 A (NO) Max. switched current: 150 V AC, 150 V DC / 2 A (NC) Max. switching capacity: 10 W (NO) / 20 W (NC) Connector plug: Protection class: Cable gland: Cable cross-section: DIN EN 175301-803 type C IP 65 PG 7, for cable Ø from 6 to 7 mm 2 x 1,5 mm² 3.3 Oil level and temperature monitoring 3.4 Caution: Magnet fields impair the proper function! Assembly sequence for cable connection 2. Push the contact holder out off the connector casing. 3.5 1. Loosen the mounting screw and pull off the connector plug. 4. Push the contact holder back into the connector casing and tighten the cable gland for strain relief grip / seal. 3.6 3. Loosen the cable gland, feed the cable through the connector casing and connect to the contact holder. 3.7 5. Push the connecting plug over the connecting contacts of the oil level indicator and secure with mounting screw. For the best possible sealing effect of the O-rings, do not overtighten the screws (max. 12 Nm). Recommended roughness of the sealing flange surface Ra = 3 μm. 3.5 Controlling, Venting, Sealing of Liquids and Gases | Page 1573 3.9 Two tapped holes M12 are required for mounting the oil level indicator GN 650.5. If nuts are used for mounting, two Ø 12.5 bore holes are required. 3.8 Assembly instructions
2210 Pages | Valable jusqu’au 12/2026 | Page précédente | Page suivante
Choisissez votre langue
Probleme juridique
Le fabricant est exclusivement responsable du contenu, des prix et des détails des articles et des offres présentés dans les catalogues. Sous réserve de modifications techniques et optiques du fabricant et sous réserve d’erreurs.
Formulaire de demande de produits spéciaux
Le service d’approvisionnement ToolTeam®
Vous recherchez des produits qui figurent dans le catalogue mais ne peuvent pas être achetés directement en ligne ?Notre service d’approvisionnement se fera un plaisir de vous faire une offre individuelle et sans engagement.
