Woelm Catalogue KWS Door Pulls, Door Handles and Accessories Página 70
Oferta para clientes comerciales**Los mejores vendedores de HELM KWS by Woelm
excluyendo el transporte
KWS Door pull fixing KWS 8A73.. S 23 - M 6 for Ø 20 door pull KWS 8B73.. S 23 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). KWS 8A79.. S 29 - M 6 for Ø 20 door pull KWS 8B79.. S 29 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Standard design steel blue passivated .06 stainless steel .80 natural finish Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Standard design for door pulls of Aluminium inner parts steel blue passivated and rosettes: .22, .23, .24, .27, .28, .29, .70 brass inner parts stainless steel and rosettes: .61, .65 stainless steel Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). inner parts stainless steel and rosettes: .82, .83 Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers, rosettes and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Order example Set ... Set Part no. Finish no. Fixing type KWS 8A73 .80 S 23.2 70 TEK_0308/06.2017
104 Páginas | Válido hasta 12/2020 | Página anterior | Página siguiente
Elija su idioma
Cuestiones jurídicas
El fabricante es el único responsable del contenido, el precio y los detalles de los productos y ofertas presentados en los catálogos. Sujeto a cambios técnicos y ópticos por parte del fabricante y a excepción de errores.
Formulario de pedido de productos especiales
El servicio de compras ToolTeam®
¿Busca productos que aparecen en el catálogo pero que no se pueden comprar directamente en línea?Nuestro servicio de compras estará encantado de hacerle una oferta individual y no vinculante.