Remko Air conditioning chilled water KWK 690 EC ZW 1662545

Chilled water chest unit for installation in intermediate spaces for wall or ceiling mounting without cover in two-pipe system with infinitely variable EC fan.
Casing made of dimensionally stable sheet steel, fully insulated.
Integrated, low-noise centrifugal EC fan with infinitely variable, thermally protected drive motor, statically and dynamically balanced.
Air inlet from the rear (horizontal) or bottom (vertical) with large-area air inlet.
Air outlet at the front (horizontal) or top (vertical) via a free air outlet opening to accommodate a connection duct.

Air cooler or air heater as heat exchanger in Cu/Al design made of seamlessly drawn copper pipe with form-fit aluminium fins for cold or hot water or water/glycol mixture up to max. 80°C. Tightness tested at the factory. Brass pipe connections in imperial design with bleed and drain valves provided on the left-hand side of the appliance at the factory. Depending on the installation variant, the coil connection side and the condensate connection can be exchanged.
Insulated condensate tray made of sheet steel for vertical installation and another condensate tray made of sheet steel for horizontal installation. Condensate connection on the side of the appliance.
Electrical connection terminals on the side of the appliance.
The medium flow rate can be regulated using an optional 3-way or 2-way valve assembly on the appliance. The appliance can be extended for a four-pipe system by installing an additional heating coil.

Available as accessories:
Condensate pump, room temperature control for surface mounting, switching relay for 4 devices, heating coil for four-pipe system, valve assembly two-pipe system, valve assembly four-pipe system, duct angle 90° air inlet, duct angle 90° air outlet, grille in aluminium, for air inlet, grille in aluminium for air outlet, electrical heating resistor, fault signal module

The devices comply with the relevant EU regulations and are CE-marked in accordance with the applicable directives.

Technical performance data:
MakeREMKO
TypeKWK 690 EC ZW
Nominal cooling capacity, total 1) [kW]6.90 (2.17 - 6.90)
Nominal cooling capacity, sensitive 1) [kW]5.46
Nominal heating capacity 2) [kW]7.70 (2.17 - 7.70)
Application area (room volume), approx. [m³]220
Working range, indoor unit [°C]+15 to +35
Air volume flow, per stage [m³/h]299 - 1230
Sound pressure level, per stage 3) [dB(A)]25.6 - 53.4
Voltage supply [V/~/Hz]230/1/50
Protection classIP X0
Electr. Rated power consumption cooling 1) [W]79
Rated electrical current consumption cooling 1) [A]0.54
Operating mediumEthylene/propylene glycol max. 35%
Operating pressure, max. medium [kPa Medium [kPa]600
Nominal volume flow, medium cooling 1) [m³/h]1.19
Nominal volume flow, medium heating 2) [m³/h]1.33
Nominal pressure losses, internal cooling 1) [kPa]10
Nominal pressure losses, internal heating 2) [kPA]11
Medium connections1/2”
Medium content [l]2, 4
Condensate connection [mm]19
Dimensions (H/W/D) [mm]226/1210/493
Weight [kg]25.0

1) Air inlet TK 27°C / FK 19°C, medium temperatures 7/12°C, 0% glycol concentration, max. air volume flow rate
2) Air inlet 20°C, medium temperatures 45/40°C, 0% glycol concentration, max. air volume flow rate
3) Distance 1.0 m in a 100m² room with a reverberation time of 0.3s