GAH ALBERTS - Hardware Profile and Sheets Page 142
Commercial customer offer**Products from catalog page
Swing hook with wood thread Thread-Ø: 12 x 55 mm Assembly note: Swing hook with wood thread: must be screwed in a minimum of 10 mm beyond the thread (70 mm) into the wooden beam so that the bending moment, the main load, does not act on the thread. The wooden beam must be at least 80 mm thick: For a 12 mm swing hook, a 9 mm drill must be used to drill to a depth of 75 mm. For a 10 mm swing hook, it must be pre-drilled to a depth of 50 mm with a 7 mm drill. In the event of dry cracks in the wood in the area of the boreholes, the hooks must be removed as there is a risk that the hooks could break due to the notch effect. Swing hook in masonry: If the wire is 10 mm thick, the S 12 dowel plug must be used to secure the swing hook in masonry;if the wire is 12 mm thick, the S 14 dowel plug must be used. The swing hook must be screwed into the dowel plug 15 mm beyond the thread. The dowel opening must be flush with the wall. Important: For all methods of fastening, the eyelets of the swing hooks must be transverse to the direction of the swing. All locations that are in contact with metal parts must always be well lubricated. All of the load-bearing parts of a swing must be inspected regularly. Only use in pairs. Dimension a Dimension b-Ø UNIT PU 5 Piece Contents Delivper PU ery time Order no. 4004338... Material: raw steel, Surface: blue galvanised, for screwing in 160 mm 11.5 mm - L 204525 Swing hook with thread Thread: M12 Thread length: 80 mm Assembly note: For swing hooks with metric thread, the lower nut must be screwed tightly to the end of the thread. The thread thickness of the hook is 12 +⁄- 0.5 mm; the hole must be 12 + 0.5 mm. The upper nut must be locked. A constant check of the nuts must be carried out. The swing hook must not move in its support under any circumstances. Important: For all methods of fastening, the eyelets of the swing hooks must be transverse to the direction of the swing. All locations that are in contact with metal parts must always be well lubricated. All of the load-bearing parts of a swing must be inspected regularly. Only use in pairs. Dimension a Dimension b-Ø UNIT PU 5 Piece Contents Delivper PU ery time Order no. 4004338... Material: raw steel, Surface: blue galvanised, for screwing through 180 mm 10 mm - L 204532 Swing anchor for fixing in the ground Screw length: 60 mm Screw Ø: 8 mm Assembly note: The supporting post does not have to be embedded in the ground. Set components: One set consists of one clip, one ground nail and one lag bolt Dimension a Dimension b-Ø Dimension c-Ø UNIT PU Contents Delivper PU ery time Order no. 4004338... Material: raw steel, Surface: galvanised, thick-film passivated, individual parts attached with cable ties 390 mm 80 mm 12 mm 6 Card 1 Piece L 204853 390 mm 100 mm 12 mm 6 Card 1 Piece L 204877 143
361 Pages | Valid until 12/2024 | Previous page | Next page
Choose your language
Legal issues
The manufacturer is exclusively responsible for the content, price and article details of the products and offers presented in the catalogues. Subject to technical and optical changes by the manufacturer and errors excepted.
Request form for special products
The ToolTeam® Procurement Service
Are you looking for products that are shown in the catalogue but cannot be purchased directly online?Our procurement service will be pleased to make you a non-binding and individual offer.