TOX product catalogue Page 59
Commercial customer offer**Top sellers from TOX-DÜBEL
Building materials & Holding values S-Fix Pro 1 Stainless steel A4 M8 M10 M12 M16 Effective anchoring depth 48 mm 60 mm 72 mm 86 mm Permissible central tension load of a single wall plug without environmental effects Nzul cracked concrete C20/25 240 kg 430 kg 570 kg 1190 kg uncracked concrete C20/25 430 kg 760 kg 950 kg 1660 kg Permissible shear load of a single anchor without environmental effects Vzul cracked concrete C20/25 570 kg 1030 kg 1500 kg 2730 kg uncracked concrete C20/25 650 kg 1030 kg 1500 kg 2800 kg permissible bending moment Mzul 13.2 Nm 26.9 Nm 46.7 Nm 118.7 Nm Component dimensions and installation characteristics 50 mm (edge distance ≥ 50 mm) 55 mm (edge distance ≥ 70 mm) 60 mm (edge distance ≥ 80 mm) 70 mm (edge distance ≥ 100 mm) 50 mm (axis distance ≥ 50 mm) 50 mm (axis distance ≥ 110 mm) 60 mm (axis distance ≥ 120 mm) 70 mm (axis distance ≥ 130 mm) Minimum component thickness hmin 100 mm 120 mm 150 mm 170 mm Drill core diameter d0 8 mm 10 mm 12 mm 16 mm Drill hole depth h1 ≥ 70 mm 80 mm 100 mm 115 mm Through hole in the component to be connected df ≤ 9 mm 12 mm 14 mm 18 mm Torque when anchoring Tinst 20 Nm 40 Nm 60 Nm 120 Nm Heavy Duty / Steel minimum centre distance smin minimum edge distance cmin When sizing, the entire declaration of performance of the S-Fix Pro 1 A4 must be observed The partial safety factors of the resistances and a partial safety factor of γF = 1.4 are to be considered Approved wall plugs must be used for fixings where safety is of importance (see also www.tox.de/safety+loads) Description & Area of Application Stainless steel A4 bolt anchor with long thread, washer and hexagonal nut Torque-controlled wall plug Small axis and edge distances for near-edge fastenings and small anchor plates Only a few hammer blows required to set the anchor The required torque is achieved with only a few revolutions Processing & Installation Approved for indoor and outdoor installation as well as in damp rooms 1. Drilling 3. Drive in anchor 2. Clean drill hole 4. Tighten nut The specified torque must be observed Through installation 59
216 Pages | Valid until 12/2023 | Previous page | Next page
Choose your language
Legal issues
The manufacturer is exclusively responsible for the content, price and article details of the products and offers presented in the catalogues. Subject to technical and optical changes by the manufacturer and errors excepted.
Request form for special products
The ToolTeam® Procurement Service
Are you looking for products that are shown in the catalogue but cannot be purchased directly online?Our procurement service will be pleased to make you a non-binding and individual offer.