AMF Catalogue Hydraulic clamping systems Page 12
Commercial customer offer**Top sellers from AMF Spannsysteme
hydraulic intensifier No. 6903 Hydraulic intensifier Temperature -40 - +120°C Article no. Rato i max. operating pressure ND [bar] max. operating pressure HD [bar] Q max. ND Q max. HD [l/min] [l/min] [g] 452060 6903-20-15 1,5 200 300 8 1,0 1000 320184 6903-20-20 2,0 200 400 12 2,0 1000 275198 6903-20-32 3,2 200 640 15 2,5 1000 320192 6903-20-40 4,0 200 800 14 2,0 1000 291526 6903-20-50 5,0 160 800 14 1,6 1000 320200 6903-20-66 6,6 120 800 13 1,3 1000 Order no. Weight ND = low pressure side, HD = high pressure side Design: Steel housing galvanized and chrome plated, piston and valve seat from steel. Oil supply via threaded port. Application: Hydraulic intensifier are used to pressurise hydraulic clamping fixtures and assembly devices. The low pressure of the tooling machine‘s hydraulic system will be converted into a higher operating pressure according to the ratio. Input pressure and output pressure are proportional. The output pressure can be adjusted by the input pressure. Features: The most important functions are shown in the hydraulic circuit diagram. Oil is guided through directional valve CV to input IN and flows unimpeded through check valves KV1, KV2 and DV and into high pressure area H. In these conditions the pressure intensifier achieves a maximum flow rate with rapid forwards motion. Once input pressure IN is achieved in high-pressure area H, valves KV1, KV2 and DV close. The output pressure is built up by oscillating pump unit OP. The unit switches itself off automatically when the output pressure is achieved in high-pressure area H. In case of pressure loss in the high-pressure area due to consumption or loss of oil, pump unit OP starts automatically in order to maintain the output pressure. Pressure can be relieved from the high pressure area via the directly controlled valve DV. Note: The hydraulic oil must be filtered with mesh size not larger than nominally 10 µm, 19/16 according ISO 4406. If the intensifier will be used for applications where the oil supply is disengaged, a leakage free pilot controlled check valve should be installed between high pressure output H and the cylinder. Please consider the min. control pressure for releasing. The design of the intensifier allows a certain leakage between the ports IN and R. This has to be considered in uncoupled operations. On request: Manifold mounting and other sizes available on request. Hydraulic diagram: High-pressure connection H Application examples: CAD Subject to technical alterations. 12 Hydraulic clamping systems ANDREAS MAIER GmbH & Co. kg ∙ Phone: +49 711 5766-196 ∙ Web: www.amf.de
384 Pages | Valid until 12/2025 | Previous page | Next page
Choose your language
Legal issues
The manufacturer is exclusively responsible for the content, price and article details of the products and offers presented in the catalogues. Subject to technical and optical changes by the manufacturer and errors excepted.
Request form for special products
The ToolTeam® Procurement Service
Are you looking for products that are shown in the catalogue but cannot be purchased directly online?Our procurement service will be pleased to make you a non-binding and individual offer.