Kukko main-catalogue - specialized in extractors Page 96
Commercial customer offer**Top sellers from Kukko
KUKKO tool factory Ball bearing removal and fitting Selection of the right ball bearing extractor The ball bearing is in a housing and on a shaft at the same time. pull pull pressure 1st step: What is the ISO number of the ball bearing? ISO ? 2nd step: Reusing of the ball bearing 2 2 Das Lager kann The bearing can nach dem Ausbau be reused wieder verwendet after removal! werden! Dasbearing Lager The mustnach be muss replaced dem Ausbau after removal! ersetzt werden! 3rd step: Choice of the right ball bearing puller 3 96 The bearing is replaced 3 The bearing can be used again Series 69 Series 70 Series 70 The cage of the damaged ball bearing needs to be drilled so that the hemispheres of the pulling parts can be screwed in. · There arise drilling chips The jaws of the puller arms catch between the balls and the outer ring of the bearing. Non-destructive pulling using the 70 series does not damage the ball bearing. The jaw of the puller arm grips between the ball and the outer ring of the bearing. · No chips are produced · No chips are produced A world in motion since 1919!
208 Pages | Valid until 12/2020 | Previous page | Next page
Choose your language
Legal issues
The manufacturer is exclusively responsible for the content, price and article details of the products and offers presented in the catalogues. Subject to technical and optical changes by the manufacturer and errors excepted.
Request form for special products
The ToolTeam® Procurement Service
Are you looking for products that are shown in the catalogue but cannot be purchased directly online?Our procurement service will be pleased to make you a non-binding and individual offer.