Woelm Catalogue KWS Door Pulls, Door Handles and Accessories Side 70
Kommercielt kundetilbud **Top-sælgere fra HELM KWS by Woelm
ekskl. forsendelsesomkostninger
KWS Door pull fixing KWS 8A73.. S 23 - M 6 for Ø 20 door pull KWS 8B73.. S 23 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). KWS 8A79.. S 29 - M 6 for Ø 20 door pull KWS 8B79.. S 29 - M 8 for Ø 25, 30, 35, 40 and 50 mm Door pull/support Standard design steel blue passivated .06 stainless steel .80 natural finish Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Standard design for door pulls of Aluminium inner parts steel blue passivated and rosettes: .22, .23, .24, .27, .28, .29, .70 brass inner parts stainless steel and rosettes: .61, .65 stainless steel Piece fixing with self-tapping sleeve, on aluminium and plastic profiles with insulation chamber, as well as solid wood doors for female part (LT). inner parts stainless steel and rosettes: .82, .83 Mounting Bore holes: M6 = Ø10 mm, M8 = Ø12 mm, bore on one side through the pre-chamber into the main chamber, solid wood doors 5 mm deeper than the respective length of the self-tapping sleeve. Screw in the selftapping sleeve with a pin spanner (SW 8) to the point until the top edge aligns with the door. Then screw in the M8 grub screw with a pin spanner (SW 4) up to 30 mm protuberance, put on plastic washers, rosettes and clamp pieces and tighten the M8 clamping nuts with a spanner (SW 11). Put on female part and tighten the clamp screws on the side with pin spanner (15 Nm). Order example Set ... Set Part no. Finish no. Fixing type KWS 8A73 .80 S 23.2 70 TEK_0308/06.2017
104 Sider | Gyldig indtil 12/2020 | Previous page | Næste side
Vælg dit sprog
Juridiske oplysninger
Producenten er kun ansvarlig for indhold, pris og artikeldetaljer for produkterne og tilbuddene i katalogerne. Med forbehold for tekniske og optiske ændringer og fejl fra producentens side.
Anmodningsskema til specialprodukter
ToolTeam® indkøbsservice
Leder du efter produkter, der er vist i kataloget, men ikke kan købes direkte online?Vores indkøbstjeneste vil med glæde give dig et uforpligtende og individuelt tilbud.