Eurotec Catalogue Lifting and Transport Solutions Side 29
Kommercielt kundetilbud **Top-sælgere fra Eurotec
Timber engineering TILTING OF CLT PANELS To tilt CLT wall panels from a horizontal position to a vertical position, the base of the wall shall act as support so that half of the gravity load is transferred through direct contact, and the lifting devices carry the other half. Therefore, the permissible capacities can be used per anchor point as shown in the table above for the CLT wall with respect to B=0° Due to out-of-plane shear loading at the initial stage, the edge distance of a4,t shall be satisfied for screws. However, screws should not be inserted in the glue line. Hence, CLT thickness should be checked as follows. Powerblock-M: · Minimum CLT wall thickness ≥ 120 mm (2 screws in the middle layer) and 160mm (4 screws at the outer layers) Powerblock-L: · Minimum CLT wall thickness ≥ 120 mm (4 screws in the middle layer) and 170mm (8 screws at the outer layers) If you are not familiar with how this product is used, and particularly with the product’s intended use, please contact our Application Technology department ([email protected]). 29
58 Sider | Gyldig indtil 12/2026 | Previous page | Næste side
Vælg dit sprog
Juridiske oplysninger
Producenten er kun ansvarlig for indhold, pris og artikeldetaljer for produkterne og tilbuddene i katalogerne. Med forbehold for tekniske og optiske ændringer og fejl fra producentens side.
Anmodningsskema til specialprodukter
ToolTeam® indkøbsservice
Leder du efter produkter, der er vist i kataloget, men ikke kan købes direkte online?Vores indkøbstjeneste vil med glæde give dig et uforpligtende og individuelt tilbud.