Eurotec catalogue fastening technology Side 184
Kommercielt kundetilbud **Top-sælgere fra Eurotec
Timber engineering Horizontal wall or beam: Set upright, then lift CLT wall or beam Connection in the End grain area Connector Lifting Anchor Mini Ø 40 mm + 8 x VSS 6 x 60 Stop bracket β 30° 248 45° 295 60° 318 75° 328 β 90° Horizontal CLT wall or beam Notes: ● The tables are based on the expert evaluation report entitled ‘LoadCarrying Capacity of Connections with E.u.r.o. Tec HebeFix Mini Lifting Anchors’ by H.J. Blaß, 01/12/2020. ● The tables illustrate the ‘Horizontal wall or beam: Set upright, then lift’ load case. ● The table values are only valid for lifting or assembly states. ● The minimum cross-section thickness for walls and beams is 100 mm. ● The minimum distances between the edges of the connectors parallel to the component plane is 200 mm. ● The connectors must be screwed into the components’ centre plane flush, plus perpendicular to the surfaces of the narrow sides and side or end grain areas. ● The values in the table apply to characteristic raw densities of min. 350 kg/m³ for CLT and 385 kg/m³ for GLT. ● According to the above-mentioned expert report, a vibration coefficient of min ϕ = 2,0 must be used. ● The values stated in the table take a vibration coefficient of ϕ = 2,0. into account. For deviating vibration coefficients, the table values must be ultiplied by the factor 2,0/ϕ. 184 Total weight [kg] with 2 strands Vertical CLT wall or beam with n strands n x 166
444 Sider | Gyldig indtil 12/2024 | Previous page | Næste side
Vælg dit sprog
Juridiske oplysninger
Producenten er kun ansvarlig for indhold, pris og artikeldetaljer for produkterne og tilbuddene i katalogerne. Med forbehold for tekniske og optiske ændringer og fejl fra producentens side.
Anmodningsskema til specialprodukter
ToolTeam® indkøbsservice
Leder du efter produkter, der er vist i kataloget, men ikke kan købes direkte online?Vores indkøbstjeneste vil med glæde give dig et uforpligtende og individuelt tilbud.