PFERD Tools Main Catalogue Strana 446
Nabídka komerčních zákazníků **Nejlépe prodávané z PFERD
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Diamond and CBN tools Safety notes and recommended cutting speeds Safety notes The operator is responsible for the grinding application, including correct tool drive use, correct handling and use of the grinding tools. Wear gloves! Wear a dust mask! Wear eye protection! Follow the safety instructions! Wear hearing protection! Recommended cutting speeds The recommended cutting speed ranges depend on the application and must not exceed the maximum permissible peripheral speed. Because of the wide range of tasks and application fields of electroplated diamond and CBN tools, as well as the large influence of the employed tool drive, it is not possible to specify a generally valid cutting speed. The recommended cutting speed ranges serve as reference values. CBN Electroplated bond Diamond Cutting speed [m/s] ▶ CBN Diamond Resinoid bond Metal bond Page Catalogue 6 5 CBN Diamond 5 Generally, the following applies: ■ In dry grinding, do not use diamond tools at too high a cutting speed in order to avoid thermal damage to the abrasive. ■ If possible, do not use CBN tools under the cutting speeds specified below. The optimum cutting speed has a direct effect on the economic efficiency of the tools in use. Dry grinding ■ All parameters must always be coordinated with each other within the grinding process. If the cutting speed is changed, the feed, infeed and coolant supply, among others, must be adjusted accordingly. ■ Electroplated diamond and CBN tools can be used in dedicated stationary applications up to a peripheral speed of 125 m/s. 5 10 15 20 25 30 15–25 m/s Dry grinding 15–25 m/s Wet grinding 20–40 m/s Dry grinding 15–20 m/s Wet grinding 20–30 m/s Dry grinding 18–30 m/s Wet grinding Wet grinding Wet grinding 40 45 ... 80 30–80 m/s for CRP/GRP as well as grey and nodular cast iron 8–18 m/s Wet grinding Dry grinding 35 25–40 m/s 10–15 m/s 15–30 m/s 25–30 m/s
724 Stránky | Platí do 12/2025 | Previous page | Další stránka
Vyberte si jazyk
Legální problémy
Výrobce je výhradně zodpovědný za obsah, cenu a detaily produktů a nabídek uvedených v katalozích. Technické a optické změny výrobce a chyby jsou vyhrazeny.
Formulář žádosti o speciální produkty
Služba nákupu ToolTeam®
Hledáte produkty, které jsou uvedeny v katalogu, ale nelze je zakoupit přímo online?Naše služba nákupu vám ráda zpracuje nezávaznou a individuální nabídku.