Matador Tool Catalogue Strana 190
Nabídka komerčních zákazníků **Produkty z katalogové stránky
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
Bez dopravy
M ATADOR Striking Tools. Hot forged and hardened as a w hole. Black lacquered surface. Very high strength through special chrome vanadium air hardening steel. Inductive hardened safety striking head Blank polished Working edges. Tried and tested industrial quality for long service life. In case of low w ear: Regrinding. In case of heavy w ear: Reforging. Safety Instructions. It goes w ithout saying that Dulled edges can be reground In case of heavy w ear and tear the The follow ing w orking safety requi- M ATADOR striking tools comply w i- several times. M ake sure that cutting edges can be reforged at any rements should be strictly observed th the DIN standards w ith respect to grinding intervals are short and time: Pay attention to the right hea- due to high risk of injury involved their form and w orkmanship. avoid excessive grinding heat in ting of the forging range (cutting ed- in the improper use of hand strik- order not to impair the hardness ge + 30 mm) up to 950 - 1050°C. ing tools: (ideal: w ater cooling). The optimal hardening temperature Chisels, center punches, drift punches and parallel pin punches is 790 - 880°C, then immediately are made of a special chrome quench in oil and heat up to a tem- vanadium air hardening steel. All perature of approx. 280°C. Ready. striking tools are entirely quenched and tempered and thus resist hard w orking stress and guarantee an especially long service life. - Alw ays w ear eye protection goggles. - Select the right striking tool and the appropriate hammer size depending to the application. - Avoid w orking on hardenend material exceeding 40 HRC due to the risk of being seriously injured Thanks to the additional inductive hardening of the striking head to 35 - 46 HRC no splintering and through splintering. - Avoid the striking head to be soiled by lubricants. beading w ill occur. - Remove burrs at the striking head Even in hard industrial w orking - Check the cutting edge of the tool regularly through grinding. stress M ATADOR striking tools w ill not break. before starting to w ork. Worn cutting edges have to be reground. - Only use striking tools for their intended purpose. 190 | Be a M ATADOR. w w w.matador.de
328 Stránky | Platí do 12/2023 | Previous page | Další stránka
Vyberte si jazyk
Legální problémy
Výrobce je výhradně zodpovědný za obsah, cenu a detaily produktů a nabídek uvedených v katalozích. Technické a optické změny výrobce a chyby jsou vyhrazeny.
Formulář žádosti o speciální produkty
Služba nákupu ToolTeam®
Hledáte produkty, které jsou uvedeny v katalogu, ale nelze je zakoupit přímo online?Naše služba nákupu vám ráda zpracuje nezávaznou a individuální nabídku.